Preparation and investigation of coal slurry fuel blended with industrial wastewater for use in thermal power generation
DOI:
https://doi.org/10.30537/sjet.v1i2.249Keywords:
Coal; spent wash; Coal Water Slurry Fuel; Coal Spent wash Slurry FuelAbstract
Coal is an important and vital fossil fuel. It has been underutilized due to its complex mining procedures, transportation constraints and environmental impacts. Pakistan has vast amount of coal reserves and at present these reserves are not yet fully exploited due to the complications in underground coal gasification and mining. The proposed innovative technology of coal water slurry fuel can make the utilization of coal more easy and environment friendly. Finely ground coal particles are blended with water and additives to formulate a liquid fuel having properties comparable to the heavy fuel oils. Another novel idea is to use industrial wastewater instead of fresh water in preparation of coal slurry fuel. Major industries in Pakistan are facing problems of energy curtailment and wastewater disposal. Both the challenges can be effectively addressed by employing the proposed concept of coal slurry fuel together with the wastewater. The effects of blending pulverized coal in wastewater and fresh water were investigated in terms of properties such as heating values, sulfur content and ash content. Pulverized coal was obtained from “Pioneer Cement”, having average particle size 90 μm, heating value of 6260 cal/g, 16.22% ash content and 0.69% sulphur content. Wastewater was collected from Noon Sugar Mills distillery having a pH of 3.92, brix 13.2, COD 101000 mg/l and BOD 35000 mg/l. Two samples of coal slurry fuel were prepared, one using fresh water and other using wastewater of alcohol distillery. Heating values were analyzed on dry basis, in case ofwastewater sample the heating value decreases by a non-noticeable margin, the new value is 6245 cal/g and in case of fresh water sample it was 6014 cal/g. Sulphur in the fuel is increased to 0.96% due to presence of sulfur containing compounds in wastewater but for fresh water sample it is 0.81%. Further, ash content of the wastewater coal slurry fuel17.86% as compare to the fresh water samplewhich was 16.72%. Both sample slurries can be fired in boilers in replacement of expensive heavy fuel oils. But in case of wastewater some post treatment is suggestedin order to reduce Sulphur contents. The analysis shows environmental friendly utilization of coal as slurry with wastewater due to reduced ash contents and maximum thermal energy extraction even by the use of low quality coal.
Downloads
References
[2] J. Werther and T. Ogada, “Sewage sludge combustion,” Prog. Energy Combust. Sci., vol. 25, no. 1, pp. 55–116, Feb. 1999.
[3] H. Masudi and S. Samudrala, “Combustion Analysis of Coal-Water Slurry Fuel Prepared From Plant Coal and Recovered Coal Fines Mechanical Engineering Department Prairie View a & M University Mechanical Engineering Department Prairie View a & M University.”
[4] F. Wang, Z. Zhou, Z. Dai, X. Gong, G. Yu, H. Liu, Y. Wang, and Z. Yu, “Development and demonstration plant operation of an opposed multi-burner coal-water slurry gasification technology,” Front. Energy Power Eng. China, vol. 1, no. 3, pp. 251–258, 2007.
[5] H. Zhao, Y. B. Hou, H. F. Liu, X. S. Tian, J. L. Xu, W. F. Li, Y. Liu, F. Y. Wu, J. Zhang, and K. F. Lin, “Influence of rheological properties on air-blast atomization of coal water slurry,” J. Nonnewton. Fluid Mech., vol. 211, pp. 1–15, 2014.
[6] D. Das, S. Panigrahi, P. K. Misra, and A. Nayak, “Effect of organized assemblies. Part 4. Formulation of highly concentrated coal-water slurry using a natural surfactant,” Energy and Fuels, vol. 22, no. 3, pp. 1865–1872, 2008.
[7] D. Chen, Y. Jiang, X. Jiang, Z. Ma, J. Yan, K. Cen, X. Yu, H. Liao, and H. Zhao, “The effect of anionic dispersants on the moisture distribution of a coal water slurry,” Fuel Process. Technol., vol. 126, pp. 122–130, 2014.
[8] G. Atesok, H. Dincer, M. Ozer, and a. Mütevellioǧlu, “The effects of dispersants (PSS-NSF) used in coal-water slurries on the grindability of coals of different structures,” Fuel, vol. 84, no. 7–8, pp. 801–808, 2005.
[9] A. Yasar, A. Ali, A. B. Tabinda, and A. Tahir, “Waste to energy analysis of shakarganj sugar mills; Biogas production from the spent wash for electricity generation,” Renew. Sustain. Energy Rev., vol. 43, pp. 126–132, 2015.
[10] S. Mohana, C. Desai, and D. Madamwar, “Biodegradation and decolourization of anaerobically treated distillery spent wash by a novel bacterial consortium,” Bioresour. Technol., vol. 98, no. 2, pp. 333–339, 2007.
[11] PSA, “Statistics.”
[12] M. Irfan, M. A. Irfan, A. Khan, I. Ullah, N. Wazir, S. Arabia, S. Arabia, and I. Estate, “The Case of Coal Water Slurry Fuel for Industrial Use in Pakistan,” vol. 9, no. 6, pp. 460–465, 2015.
Downloads
Published
Issue
Section
License
The SJET holds the rights of all the published papers. Authors are required to transfer copyrights to journal to make sure that the paper is solely published in SJET, however, authors and readers can freely read, download, copy, distribute, print, search, or link to the full texts of its articles and to use them for any other lawful purpose.
The SJET is licensed under Creative Commons Attribution-NonCommercial 4.0 International License.
